285-410044 MOTOMASTER Mini Side-By-Side - ChassisRegular price $9.95
The Mini Side-By-Side Chassis, is a complete unit, without the Body or the Body Tabs.
Charging The MOTOMASTER Mini Side-By-Side
It requires a full charge before and after use. Please let the battery and motor cool off for 10 minutes before charging, as damage may result from charging a hot battery. When not in use, or charging, always keep the trucks start switch turned off.
Your MOTOMASTER Mini-Side-B-Side comes with a Li-Po battery which is inside the model. The rechargeable Li-Po battery provides the power to propel your model at high speeds. You should expect 8-12 min run time. However you do need to make sure to properly maintain your Li-Po Battery.
- Li-Po batteries don’t like to be run down too low. If the voltage is dropped dramatically they will be damaged and will not recharge! Once the model starts to slow, drive your model to a safe place, walk over and turn it off.
- It is recommend to charge the battery after your run and to always store the battery with a charge. Never discharge or dead short a Li-Po battery! Always have your model turned off when not in use. Make sure the switch is turned OFF.
The Info Manual describes the Light sequence in the opposite manner as described here. Some of the Mini's are equipped with those USB chargers and they work just the same.
1/ Plug the USB into your computer, TV, or USB charger. The LED light on the USB will turn RED.
2/ Plug the other end of the cable into your MOTOMASTER MINI's battery port located at the bottom of the model. Do not force the plug, it only goes in one way. The model must have the power switch in the OFF position. The LED light on the USB Charger will turn OFF.
3/ Charge time can take up to 30 minute (shorter if charging for the first time). Once charged the LED light on the USB will turn back to solid RED.
Tip: If storing for more than 24 hours it is best to store with a fully charged battery. Failure to do so can damage the battery pack and shorten its useful life.
Synchronizing Your Mini with your Transmitter
MOTOMASTER MINIs are ready to use - however you must follow these steps carefully:
1. Switch on the transmitter. The light will blink.
2. Turn the MINIs power switch on. It has a red power light that will come on solid. The light on the transmitter will now turn solid. You are ready to go!